ABS Sensor Ford F-150

Ford F150 ABS sensor test & replacement video. Watch how to testing and replacing an ABS sensor on a 2002 Ford F-150 FX4 truck. ABS sensor replacement on front driver side. Part# 970-074 Dorman.

How to Change an ABS Wheel Sensor. Ford Taurus

ALS114 Rear Wheel ABS Sensor for Ford Taurus & Mercury Sable1990-1995

The anti-lock braking system (ABS) on the Ford Taurus uses a wheel sensor to monitor the wheel speed on each wheel. The ABS controller uses this information to prevent the brakes from locking during an emergency stop. If the ABS warning light comes on, it may indicate the wheel sensor has become clogged with metallic debris such as brake dust.


Things You'll Need:
New ABS wheel sensor
Socket wrench set
Thread-locking compound
Torque wrench


Determine which ABS wheel sensor your Ford Taurus will need. You'll want to be sure the new wheel sensor is compatible with your make and model of Taurus. All versions of the Taurus have been equipped with ABS since its debut in 1999.


Unhook the negative battery cable with a socket wrench and raise the vehicle.


Unplug the electrical connection from the front wheel speed sensor located in the engine compartment. Remove the plastic studs for the splash shield on the front fender.


Detach the grommets for the wheel speed sensor cable at the rail bracket and retainer on the strut housing. Remove the wheel speed sensor retaining bolt with a socket wrench and separate the sensor from the steering knuckle.


Disconnect the wheel speed sensor on rear wheels from the electrical cable in the center of the cross member. Release the retaining clips from the suspension arm and cross member.


Remove the wheel speed sensor retaining bolt with a socket wrench. This bolt attaches to the brake adapter on station wagons and the brake spindle on sedans. Separate the wheel speed sensor assembly from the vehicle.


Install the new wheel speed sensor by reversing the removal procedure. Apply thread-locking compound to the retaining bolt and use a torque wrench tighten it to between 90 and 120 for front wheel sensors. Torque the mounting bolts for rear wheel speed sensors to between 62 and 98 in. lbs.

Source

ABS sensors Chrysler Town and Country 2008 Testing

Testing the ABS sensors on a 2008 Chrysler Town and Country video. Testing the signals on an ABS sensor on a Chrysler Town Country 2008. These are new sensors that are working properly. The old sensors were replaced due to codes C1020 and C102B. The voltage supply is at 12 volts and that is the wire where the speed sensor signal is seen

How to replace abs sensor Chrysler Pacifica

REMOVAL
1. Access and remove rear hub and bearing from vehicle.
2. Remove screw fastening speed sensor head to hub and bearing. See Fig. 4

Fig. 4: Rear Hub And Bearing With Wheel Speed Sensor

1. SCREW
2. WHEEL SPEED SENSOR
3. HUB AND BEARING

CAUTION: Prior to removal, clean area around sensor head to help prevent contaminants from entering bearing when sensor head is removed.

3. Remove wheel speed sensor from hub and bearing.

INSTALLATION
1. Apply bearing grease (supplied with part) to sensor head shaft and O-ring.
2. Push sensor head into mounting hole in hub and bearing and align mounting screw hole.
3. Install NEW mounting screw. See Fig. 4. Tighten mounting screw to 20 N.m (15 ft. lbs.) torque.
4. Install hub and bearing with wheel speed sensor as well as all com ponents necessary to access it.
5. Road test vehicle to ensure proper operation of the base brakes and ABS

Buy cheap Standard Motor Products ALS1125 Rear Wheel ABS Sensor for ChryslerPacifica 2005-2007